Extrusion Pullers
The Belco Extrusion Puller keeps constant tension on the profiles during the extrusion cycle.
Extrusion Systems
Hot Extrusion Saw Conveyor
The Belco Saw Roller Conveyor is located between the press platen and run-out conveyor and serves as the initial lead out table.
- Press platen
- Hot extrusion saw conveyor
- Run-out conveyor
Hot extrusion saw roller conveyor
The saw is designed to operate in conjunction with the extrusion puller and will cut during the press dead cycle in single puller mode and cut on the fly in dual puller mode. The saw proper is attached to the conveyor chains and rollers fill the remaining lead out area. The saw retracts below the height of the roller conveyor so that the unit can be used as a standard lead out table. The saw is a self-contained, floor-mounted unit designed to match the press and run-out table height.
Hot extrusion saw conveyor FAQs
Where does the saw roller conveyor sit on the line?
Between the press platen and the run-out conveyor, where it serves as the initial lead out table. It is a self-contained, floor-mounted unit designed to match the press and run-out table height.
Can it be used as a plain lead out table when the saw is not needed?
Yes. The saw retracts below the height of the roller conveyor so the unit can be used as a standard lead out table.
When does the saw cut?
It operates in conjunction with the extrusion puller, cutting during the press dead cycle in single puller mode and cutting on the fly in dual puller mode.
What cut designs are available?
Either an under table cut or a cross cut design.
Related
Quench Systems
The Belco Flood Quench is a standing wave-style water quench located at the press exit between the leadout table and the runout table.